Scroll saw maintenance and specifications: Difference between revisions
Jump to navigation
Jump to search
Aspontarelli (talk | contribs) (Created page with "{| |width="33%"| '''Shop Area:''' Woodshop '''Tool:''' DeWalt 20" Scroll Saw '''Requires in-person training:''' Yes |width="33%"| '''Procedure Number''' MT 110-09,...") |
No edit summary |
||
| (2 intermediate revisions by the same user not shown) | |||
| Line 9: | Line 9: | ||
'''Procedure Number''' | '''Procedure Number''' | ||
MT 110-09, Rev. | MT 110-09, Rev. 1 | ||
|width="33%"| | |width="33%"| | ||
'''Date''' | '''Date''' | ||
1/26/2021 | |||
|} | |} | ||
= General = | = General = | ||
[[File:DeWalt Scroll Saw.png]] | |||
= Reference = | = Reference = | ||
| Line 47: | Line 48: | ||
TBD | TBD | ||
''' | '''END OF THE PROCEDURE''' | ||
Latest revision as of 14:20, 26 January 2021
|
Shop Area: Woodshop Tool: DeWalt 20" Scroll Saw Requires in-person training: Yes |
Procedure Number MT 110-09, Rev. 1 |
Date 1/26/2021 |
General
Reference
Maintenance
BRUSHES
- Inspect carbon brushes regularly by unplugging tool, removing the brush inspection cap and withdrawing the brush assembly.
- Keep brushes clean and sliding freely in their guides.
- Always replace a used brush in the same orientation in the holder as it was prior to its removal. If the brush is worn down to 3/8", it must be replaced.
- The tool should be allowed to “run in” (run at no load) for 10 minutes before use to seat new brushes.
Installing the Blade
- BEFORE INSTALLING A BLADE, UNPLUG THE SCROLL SAW.
- The blade is held in place by the thumbscrew blade clamps attached to the top and bottom arms of the scroll saw.
- Before installing a blade, make sure the blade tension lever is moved fully to the right.
- Loosen, but do not unscrew, the top and bottom thumbscrews.
- Thread the blade through the hole in table, with the teeth facing toward the front of the saw.
- Scroll saws cut on the down-stroke, so it is essential that teeth face forward and down.
- Insert the blade into the bottom blade clamp and securely tighten the thumbscrew.
- Next, insert the top of the blade into the top blade clamp and securely tighten the top thumbscrew.
- Properly adjust the tension of the blade before operating your scroll saw.
Specifications
TBD
END OF THE PROCEDURE