Roll Bender: Difference between revisions
Jump to navigation
Jump to search
Aspontarelli (talk | contribs) (Created page with "{| |width="33%"| '''Shop Area:''' Metal Shop '''Tool:''' Hulk Tube Roller '''Requires in-person training:''' No |width="33%"| '''Procedure Number''' UG 130-14, Rev. 0 |wid...") |
Aspontarelli (talk | contribs) No edit summary |
||
(5 intermediate revisions by the same user not shown) | |||
Line 3: | Line 3: | ||
'''Shop Area:''' Metal Shop | '''Shop Area:''' Metal Shop | ||
'''Tool:''' | '''Tool:''' Roll Bender | ||
'''Requires in-person training:''' No | '''Requires in-person training:''' No | ||
Line 17: | Line 17: | ||
= GENERAL = | = GENERAL = | ||
[[File:roll_bender.jpg|350px|right]] | |||
This is a manual roll bender, good for making large radius bends in round tubing, round pipe, square, rectangle, flat stock, handrail cap, and channel. | |||
* Round Mild Steel Capacity: 2-1/2 OD x .120 | |||
* Nominal PIPE Capacity: 2" schedule 40 | |||
* Square Mild Steel Capacity: 2 x .125 | |||
= SAFETY = | = SAFETY = | ||
Line 25: | Line 29: | ||
= REFERENCE = | = REFERENCE = | ||
* Manual (https://www.trick-tools.com/common/documentation/hulk_setup.pdf) | |||
* Basic use (https://www.youtube.com/watch?v=IpQkYf5YQVo) | |||
* Tips and tricks (https://www.youtube.com/watch?v=YaJ9oOzvkpY) | * Tips and tricks (https://www.youtube.com/watch?v=YaJ9oOzvkpY) | ||
Latest revision as of 08:31, 23 January 2021
Shop Area: Metal Shop Tool: Roll Bender Requires in-person training: No |
Procedure Number UG 130-14, Rev. 0 |
Date DRAFT |
GENERAL
This is a manual roll bender, good for making large radius bends in round tubing, round pipe, square, rectangle, flat stock, handrail cap, and channel.
- Round Mild Steel Capacity: 2-1/2 OD x .120
- Nominal PIPE Capacity: 2" schedule 40
- Square Mild Steel Capacity: 2 x .125
SAFETY
REFERENCE
- Manual (https://www.trick-tools.com/common/documentation/hulk_setup.pdf)
- Basic use (https://www.youtube.com/watch?v=IpQkYf5YQVo)
- Tips and tricks (https://www.youtube.com/watch?v=YaJ9oOzvkpY)
PROCEDURE
TROUBLESHOOTING
THIS IS THE END OF THE PROCEDURE