Plasma Cutter (handheld) User Guide

Shop Area: Metal Shop Tool: Plasma Cutter (handheld) Requires in-person training: Yes Procedure Number: UG 110-03, Rev. 1 Last Revision: 4/30/2021

GENERAL

The RazorCut 45 plasma cutter is used for making curved cuts in metal. It can cut up to 5/8" thick steel and 1/4" aluminum.

RazorCut 45

REFERENCE

• Razor Cut 45 product page (http://razorweld.com/catalogue_product.asp?product=983&category=22&subcategory=87)
• General plasma cutting info (https://www.millerwelds.com/resources/article-library/how-to-select-and-operate-a-hand-held-plasma-cutter)
• All about plasma cutting (https://www.georgesplasmacuttershop.com/all-about-plasma-cutting-3)

PROCEDURE

1. Connect the Plasma cutter to compressed air.
2. Ensure that the settings on the plasma cutter are correct (Power, 4T, )
3. Connect ground clamp to workpiece.
4. Set plasma torch in position to cut.
5. Pull trigger until arc begins.
6. Pull trigger a second time to make cut.
7. Pull trigger a third time to ramp down power.
8. Pull trigger a fourth time to turn off.