Plasma Cutter (handheld) User Guide: Difference between revisions

From vector-space.org
Jump to navigation Jump to search
Line 16: Line 16:
= GENERAL =
= GENERAL =


The RazorCut 45 plasma cutter is used for making curved cuts in metal.
The RazorCut 45 plasma cutter is used for making curved cuts in metal. It can cut up to 5/8" thick steel and 1/4" aluminum.


= SAFETY =
= SAFETY =

Revision as of 16:04, 30 April 2021

Shop Area: Metal Shop

Tool: Plasma Cutter (handheld)

Requires in-person training: Yes

Procedure Number: UG 110-03, Rev. 1

Last Revision: 4/30/2021


GENERAL

The RazorCut 45 plasma cutter is used for making curved cuts in metal. It can cut up to 5/8" thick steel and 1/4" aluminum.

SAFETY

REFERENCE

Razor Cut 45 product page (http://razorweld.com/catalogue_product.asp?product=983&category=22&subcategory=87)

PROCEDURE

  1. Connect the Plasma cutter to compressed air.
  2. Ensure that the settings on the plasma cutter are correct (Power, 4T, )
  3. Connect ground clamp to workpiece.
  4. Set plasma torch in position to cut.
  5. Pull trigger until arc begins.
  6. Pull trigger a second time to make cut.
  7. Pull trigger a third time to ramp down power.
  8. Pull trigger a fourth time to turn off.

TROUBLESHOOTING