Plasma Cutter (handheld) User Guide: Difference between revisions
Jump to navigation
Jump to search
Aspontarelli (talk | contribs) |
Aspontarelli (talk | contribs) |
||
Line 24: | Line 24: | ||
= PROCEDURE = | = PROCEDURE = | ||
# Connect the Plasma cutter to compressed air. | |||
# Ensure that the settings on the plasma cutter are correct (Power, 4T, ) | |||
# Connect ground clamp to workpiece. | |||
# Set plasma torch in position to cut. | |||
# Pull trigger until arc begins. | |||
# Pull trigger a second time to make cut. | |||
# Pull trigger a third time to ramp down power. | |||
# Pull trigger a fourth time to turn off. | |||
= TROUBLESHOOTING = | = TROUBLESHOOTING = |
Revision as of 15:58, 30 April 2021
Shop Area: Metal Shop Tool: Plasma Cutter (handheld) Requires in-person training: Yes Procedure Number: UG 110-03, Rev. 1 Last Revision: 4/30/2021 |
GENERAL
The RazorCut 45 plasma cutter is used for making curved cuts in metal.
SAFETY
REFERENCE
PROCEDURE
- Connect the Plasma cutter to compressed air.
- Ensure that the settings on the plasma cutter are correct (Power, 4T, )
- Connect ground clamp to workpiece.
- Set plasma torch in position to cut.
- Pull trigger until arc begins.
- Pull trigger a second time to make cut.
- Pull trigger a third time to ramp down power.
- Pull trigger a fourth time to turn off.