Plasma Cutter (handheld) User Guide: Difference between revisions
Jump to navigation
Jump to search
Aspontarelli (talk | contribs) |
Aspontarelli (talk | contribs) |
||
| (6 intermediate revisions by the same user not shown) | |||
| Line 16: | Line 16: | ||
= GENERAL = | = GENERAL = | ||
The RazorCut 45 plasma cutter is used for making curved cuts in metal. | The RazorCut 45 plasma cutter is used for making curved cuts in metal. It can cut up to 5/8" thick steel and 1/4" aluminum. | ||
[[File:Razorcut45.jpg|thumb|left|RazorCut 45]] <br style="clear:left;" /> | |||
= SAFETY = | = SAFETY = | ||
= REFERENCE = | = REFERENCE = | ||
* Razor Cut 45 product page (http://razorweld.com/catalogue_product.asp?product=983&category=22&subcategory=87) | |||
* General plasma cutting info (https://www.millerwelds.com/resources/article-library/how-to-select-and-operate-a-hand-held-plasma-cutter) | |||
* All about plasma cutting (https://www.georgesplasmacuttershop.com/all-about-plasma-cutting-3) | |||
= PROCEDURE = | = PROCEDURE = | ||
# Connect the Plasma cutter to compressed air. | |||
# Ensure that the settings on the plasma cutter are correct (Power, [https://forum.langmuirsystems.com/t/intermittent-torch-firing-troubleshooting-guide/3159 4T], ) | |||
# Connect ground clamp to workpiece. | |||
# Set plasma torch in position to cut. | |||
# Pull trigger until arc begins. | |||
# Pull trigger a second time to make cut. | |||
# Pull trigger a third time to ramp down power. | |||
# Pull trigger a fourth time to turn off. | |||
= TROUBLESHOOTING = | = TROUBLESHOOTING = | ||
Latest revision as of 06:41, 3 May 2021
|
Shop Area: Metal Shop Tool: Plasma Cutter (handheld) Requires in-person training: Yes Procedure Number: UG 110-03, Rev. 1 Last Revision: 4/30/2021 |
GENERAL
The RazorCut 45 plasma cutter is used for making curved cuts in metal. It can cut up to 5/8" thick steel and 1/4" aluminum.
SAFETY
REFERENCE
- Razor Cut 45 product page (http://razorweld.com/catalogue_product.asp?product=983&category=22&subcategory=87)
- General plasma cutting info (https://www.millerwelds.com/resources/article-library/how-to-select-and-operate-a-hand-held-plasma-cutter)
- All about plasma cutting (https://www.georgesplasmacuttershop.com/all-about-plasma-cutting-3)
PROCEDURE
- Connect the Plasma cutter to compressed air.
- Ensure that the settings on the plasma cutter are correct (Power, 4T, )
- Connect ground clamp to workpiece.
- Set plasma torch in position to cut.
- Pull trigger until arc begins.
- Pull trigger a second time to make cut.
- Pull trigger a third time to ramp down power.
- Pull trigger a fourth time to turn off.