Plasma Cutter (handheld) User Guide: Difference between revisions
Jump to navigation
Jump to search
Aspontarelli (talk | contribs) |
Aspontarelli (talk | contribs) |
||
Line 16: | Line 16: | ||
= GENERAL = | = GENERAL = | ||
The RazorCut 45 plasma cutter is used for making curved cuts in metal. | The RazorCut 45 plasma cutter is used for making curved cuts in metal. It can cut up to 5/8" thick steel and 1/4" aluminum. | ||
= SAFETY = | = SAFETY = |
Revision as of 16:04, 30 April 2021
Shop Area: Metal Shop Tool: Plasma Cutter (handheld) Requires in-person training: Yes Procedure Number: UG 110-03, Rev. 1 Last Revision: 4/30/2021 |
GENERAL
The RazorCut 45 plasma cutter is used for making curved cuts in metal. It can cut up to 5/8" thick steel and 1/4" aluminum.
SAFETY
REFERENCE
Razor Cut 45 product page (http://razorweld.com/catalogue_product.asp?product=983&category=22&subcategory=87)
PROCEDURE
- Connect the Plasma cutter to compressed air.
- Ensure that the settings on the plasma cutter are correct (Power, 4T, )
- Connect ground clamp to workpiece.
- Set plasma torch in position to cut.
- Pull trigger until arc begins.
- Pull trigger a second time to make cut.
- Pull trigger a third time to ramp down power.
- Pull trigger a fourth time to turn off.