Plasma Cutter (handheld) User Guide: Difference between revisions
Jump to navigation
Jump to search
Aspontarelli (talk | contribs) |
Aspontarelli (talk | contribs) |
||
Line 23: | Line 23: | ||
= PROCEDURE = | = PROCEDURE = | ||
1. Connect the Plasma cutter to compressed air. | |||
2. Ensure that the settings on the plasma cutter are correct (Power, 4T, ) | |||
3. Connect ground clamp to workpiece. | |||
4. Set plasma torch in position to cut. | |||
5. Pull trigger until arc begins. | |||
6. Pull trigger a second time to make cut. | |||
7. Pull trigger a third time to ramp down power. | |||
8. Pull trigger a fourth time to turn off. | |||
= TROUBLESHOOTING = | = TROUBLESHOOTING = |
Revision as of 15:57, 30 April 2021
Shop Area: Metal Shop Tool: Plasma Cutter (handheld) Requires in-person training: Yes Procedure Number: UG 110-03, Rev. 1 Last Revision: 4/30/2021 |
GENERAL
The RazorCut 45 plasma cutter is used for making curved cuts in metal.
SAFETY
REFERENCE
PROCEDURE
1. Connect the Plasma cutter to compressed air. 2. Ensure that the settings on the plasma cutter are correct (Power, 4T, ) 3. Connect ground clamp to workpiece. 4. Set plasma torch in position to cut. 5. Pull trigger until arc begins. 6. Pull trigger a second time to make cut. 7. Pull trigger a third time to ramp down power. 8. Pull trigger a fourth time to turn off.