Drum sander maintenance and specifications: Difference between revisions
Jump to navigation
Jump to search
Aspontarelli (talk | contribs) |
Aspontarelli (talk | contribs) |
||
Line 44: | Line 44: | ||
- drive belt is 4L560 V-Belt (56in long by 1/2in wide) | - drive belt is 4L560 V-Belt (56in long by 1/2in wide) | ||
- conveyor belt is 23x62" | |||
'''END OF THE PROCEDURE''' | '''END OF THE PROCEDURE''' |
Revision as of 14:20, 17 August 2021
Shop Area: Woodshop Tool: Drum Sander Requires in-person training: Yes |
Procedure Number MT 110-10, Rev. 0 |
Date 4/19/2021 |
General
We have 3 Drum Sanders, see details below. This guide provides information based on the Performax Drum Sander and are similar to the use of the Jet Drum Sanders.
Reference
Maintenance
Perform the following recommended maintenance procedures on a monthly basis:
- Lubricate conveyor bushings and check for wear.
- Lubricate all moving parts, such as threaded rods, washers, and column tubes.
- Clean sawdust from the sandpaper and the conveyor belt.
- Blow dust from the inside of sanding drum(s) and the motors.
- Check all set screws for tightness on parts such as table support castings, bearings, conveyor coupler, castings, pulleys, and miter gears.
Cleaning Abrasive Strips. Regularly clean the abrasive strips on the drums with commercially available cleaning sticks, following the manufacturer’s directions. When cleaning, also brush the stick crumbs from the drum while it is still rotating.
Specifications
- drive belt is 4L560 V-Belt (56in long by 1/2in wide) - conveyor belt is 23x62"
END OF THE PROCEDURE