Drum sander maintenance and specifications: Difference between revisions
Jump to navigation
Jump to search
(Created page with "{| |width="33%"| '''Shop Area:''' Woodshop '''Tool:''' Drum Sander '''Requires in-person training:''' Yes |width="33%"| '''Procedure Number''' MT 110-10, Rev. 0 |width=...") |
Aspontarelli (talk | contribs) |
||
| Line 42: | Line 42: | ||
[[File:Drum Sander Specs.png]] | [[File:Drum Sander Specs.png]] | ||
- drive belt is 4L540 V-Belt (54in long by 1/2in wide) | |||
'''END OF THE PROCEDURE''' | '''END OF THE PROCEDURE''' | ||
Revision as of 13:55, 2 August 2021
|
Shop Area: Woodshop Tool: Drum Sander Requires in-person training: Yes |
Procedure Number MT 110-10, Rev. 0 |
Date 4/19/2021 |
General
We have 3 Drum Sanders, see details below. This guide provides information based on the Performax Drum Sander and are similar to the use of the Jet Drum Sanders.
Reference
Maintenance
Perform the following recommended maintenance procedures on a monthly basis:
- Lubricate conveyor bushings and check for wear.
- Lubricate all moving parts, such as threaded rods, washers, and column tubes.
- Clean sawdust from the sandpaper and the conveyor belt.
- Blow dust from the inside of sanding drum(s) and the motors.
- Check all set screws for tightness on parts such as table support castings, bearings, conveyor coupler, castings, pulleys, and miter gears.
Cleaning Abrasive Strips. Regularly clean the abrasive strips on the drums with commercially available cleaning sticks, following the manufacturer’s directions. When cleaning, also brush the stick crumbs from the drum while it is still rotating.
Specifications
- drive belt is 4L540 V-Belt (54in long by 1/2in wide)
END OF THE PROCEDURE