Drum-sander: Difference between revisions
(→SAFETY) |
|||
Line 27: | Line 27: | ||
= SAFETY = | = SAFETY = | ||
* Always wear approved safety glasses or face shield while operating the equipment. | |||
* Before operating equipment, remove tie, rings, watches and other jewelry, and roll sleeves up past the elbows. Remove all loose clothing and confine long hair. | |||
* Non-slip footwear or anti-skid floor strips are recommended. | |||
* Closed toe shoes are required when working in a shop area. | |||
* Do not wear gloves while operating the equipment. | |||
* Make all machine adjustments or maintenance with the machine unplugged from the power source. | |||
* Always feed stock against the drum rotation. | |||
* Never place hands or fingers under the drum or dust cover. | |||
* Keep hands and clothing away from operating drums. | |||
* Never operate the sander without its dust cover or drum and belt guarding in place. | |||
* Always maintain control of boards to avoid kickback. | |||
* Always disconnect electrical power before doing any servicing or adjusting of the machine. | |||
* Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting, and any other conditions that may affect its operation. | |||
= REFERENCE = | = REFERENCE = |
Revision as of 10:57, 15 April 2021
Shop Area: Woodshop Tool: Drum Sander Requires in-person training: Yes |
Procedure Number UG 110-10, Rev. 1 |
Date 4/1/2021 |
GENERAL
We have 3 Drum Sanders, see details below. This guide provides information based on the Performax Drum Sander and are similar to the use of the Jet Drum Sanders.
Jet Benchtop Sander Model 10-20 Plus Model 10-20 Plus has a powerful 1 HP TEFC motor with an infinitely variable feed rate of 0-12 ft./min. and a drum speed of 1700 RPM that gives you all the power you need to sand furniture stock, musical instrument pieces, craft or scrolling saw projects to an ultra smooth finish. Can sand a maximum width of 20" (two passes) and a minimum length of 2-1/4". Maximum sanding thickness is 3". Can sand down to a minimum of 1/32".
SAFETY
- Always wear approved safety glasses or face shield while operating the equipment.
- Before operating equipment, remove tie, rings, watches and other jewelry, and roll sleeves up past the elbows. Remove all loose clothing and confine long hair.
- Non-slip footwear or anti-skid floor strips are recommended.
- Closed toe shoes are required when working in a shop area.
- Do not wear gloves while operating the equipment.
- Make all machine adjustments or maintenance with the machine unplugged from the power source.
- Always feed stock against the drum rotation.
- Never place hands or fingers under the drum or dust cover.
- Keep hands and clothing away from operating drums.
- Never operate the sander without its dust cover or drum and belt guarding in place.
- Always maintain control of boards to avoid kickback.
- Always disconnect electrical power before doing any servicing or adjusting of the machine.
- Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting, and any other conditions that may affect its operation.
REFERENCE
PROCEDURE
TROUBLESHOOTING
END OF THE PROCEDURE