Cnc plasma maintenance and specifications
Jump to navigation
Jump to search
Shop Area: Metal Shop Tool: CNC Plasma Cutter Requires in-person training: Yes |
Procedure Number MT 130-05, Rev. 1 |
Date 2/8/2021 |
General
We run a Lotos LTP5500 plasma cutter on the Langmuir Crossfire CNC plasma table.
Langmuir Crossfire CNC Plasma Table.
Reference
- https://www.langmuirsystems.com/troubleshooting
- https://www.langmuirsystems.com/crossfire/legacy
- https://unimig.com.au/wp-content/uploads/2019/08/RAZOR-CUT-45-Manual.pdf
Maintenance
Exposure to extremely dusty, damp, or corrosive air is damaging to the welding/cutting machine. In order to prevent any possible failure or fault of this welding/ cutting equipment, clean the dust at regular intervals with clean and dry compressed air of required pressure.
Specifications
CROSSFIRE™ SPECIFICATIONS
- Cutting Envelope Dimensions:25.3” (X) x 23.3” (Y) x 3.0" (Z)
- Machine Weight:130 Pounds
- Linear Bearing Type: Ball Bearing Carriages on Zinc-plated Steel Tube Rails
- Stepper Motor Size: X-Axis 284 oz-in Y-Axis 425 oz-in
- PC Interface: Windows USB
- Mechanical Drive System:3/8”-8 4-Start ACME Lead Screws and Acetal Anti-Backlash Lead Nuts
- Motion Accuracy:0.002” per 12” inches
- Step Resolution:0.0005”
- Maximum Cut Speed:300 ipm
- Torch Height Control: Manual Torch Height Adjustment
- Table Surface: Replaceable Steel Slats, 50mm wide x 3mm thick
- Input Power: 110/220 VAC (selectable)
END OF THE PROCEDURE