Revision as of 16:50, 30 May 2024

Shop Area: Woodshop

Tool: Edge Sander

Requires in-person training: Yes

Procedure Number

MT 110-11, Rev. 0

Date

5/30/2024

General

Powermatic 6108 Edge sander.

Perform the following recommended maintenance procedures on a monthly basis:

                                  END OF THE PROCEDURE

@@ Line 23: / Line 23: @@
 = Maintenance =
-== Adjusting Belt Tracking ==
-According to the internet and belt grinders, belts move toward higher tension, but I swear this thing moves away from tension.
 == Regular Maintenance ==
 Perform the following recommended maintenance procedures on a monthly basis:
-* Lubricate conveyor bushings and check for wear.
-* Lubricate all moving parts, such as threaded rods, washers, and column tubes.
-* Clean sawdust from the sandpaper and the conveyor belt.
-* Blow dust from the inside of sanding drum(s) and the motors.
-* Check all set screws for tightness on parts such as table support castings, bearings, conveyor coupler, castings, pulleys, and miter gears.
-'''Cleaning Abrasive Strips.''' Regularly clean the abrasive strips on the drums with commercially available cleaning sticks, following the manufacturer’s directions. When cleaning, also brush the stick crumbs from the drum while it is still rotating.
 = Specifications =