Revision as of 15:05, 1 April 2021

Shop Area: Woodshop

Tool: Band Saw

Procedure Number

TC 110-01, Rev. 1

Date

4/1/2021

GENERAL

Training to be completed prior to using the Band Saw.

See User Guide UG-110-01

√ Indicates review completed

	Reviewed User Guide UG-110-01
	Understanding of safety requirements for operation of equipment
	Walk through set-up and operation guidelines
	Demonstrate splitting, cutting curves, circles, and notches using a band saw
	Review proper blade selection for the desired cut
	Discuss clamping and fixturing methods
	Discuss use of blade guard, guides and pushers
	Review table tilting for desired angle of cut
	Discuss Troubleshooting areas
	Demonstrate proper cleaning after use

Vector Space User: Date training completed:

Vector Space Trainer:

                                            END OF THE PROCEDURE

@@ Line 7: / Line 7: @@
 '''Procedure Number'''
-TC 110-01, Rev. 0
+TC 110-01, Rev. 1
 |width="33%"|
 '''Date'''
-DRAFT
+/1/2021
 |}
@@ Line 74: / Line 74: @@
-THIS IS THE END OF THE PROCEDURE
+                                             END OF THE PROCEDURE