Edge sander maintenance and specifications: Difference between revisions

From vector-space.org
Jump to navigation Jump to search

Aspontarelli (talk | contribs)

4 user groups
817 edits
VisualWikitext
Created page with "{| |width="33%"| '''Shop Area:''' Woodshop '''Tool:''' Edge Sander '''Requires in-person training:''' Yes  |width="33%"| '''Procedure Number''' MT 110-11, Rev. 0 |width="33%"| '''Date''' 5/30/2024 |} = General = Powermatic 9108 Edge sander. = Reference = * WB-37 Manual: https://vector-space.org/wiki/File:Powermatic_WB-37_Manual.pdf = Maintenance = == Adjusting Belt Tracking == According to the internet and belt grinders, b..."
 
 
(10 intermediate revisions by the same user not shown)
Line 17: Line 17:


= General =
= General =
Powermatic 9108 Edge sander.
Powermatic 6108 Edge sander.
= Reference =
= Reference =


* WB-37 Manual: [[Media:Powermatic WB-37 Manual.pdf|https://vector-space.org/wiki/File:Powermatic_WB-37_Manual.pdf]]
* Powermatic Edge Sander Manual: [[Media:6108.pdf|https://vector-space.org/wiki/File:6108.pdf]]
 
 


= Maintenance =
= Maintenance =
== Adjusting Belt Tracking ==
According to the internet and belt grinders, belts move toward higher tension, but I swear this thing moves away from tension.


== Regular Maintenance ==
== Regular Maintenance ==
Perform the following recommended maintenance procedures on a monthly basis:
Perform the following recommended maintenance procedures on a monthly basis:
* Lubricate conveyor bushings and check for wear.
* Lubricate all moving parts, such as threaded rods, washers, and column tubes.
* Clean sawdust from the sandpaper and the conveyor belt.
* Blow dust from the inside of sanding drum(s) and the motors.
* Check all set screws for tightness on parts such as table support castings, bearings, conveyor coupler, castings, pulleys, and miter gears.


'''Cleaning Abrasive Strips.''' Regularly clean the abrasive strips on the drums with commercially available cleaning sticks, following the manufacturer’s directions. When cleaning, also brush the stick crumbs from the drum while it is still rotating.
= Specifications =


= Specifications =


[[File:B-37_motor_nameplate.jpg|400px|thumb|WB-37 Motor Nameplate]]
[[File:Powermatic Edge Sander Motor Nameplate.jpg|400px|thumb|Powermatic Edge Sander Motor Nameplate]]
*20 HP, 3 phase, 220V Motor
*1.5 HP, 1 phase, 220V Motor
*
* Belt Size: 6 x 108"




                                   '''END OF THE PROCEDURE'''
                                   '''END OF THE PROCEDURE'''

Latest revision as of 17:08, 30 May 2024

Shop Area: Woodshop

Tool: Edge Sander

Requires in-person training: Yes 

Procedure Number

MT 110-11, Rev. 0

Date

5/30/2024

General

Powermatic 6108 Edge sander.

Reference

 

Maintenance

Regular Maintenance

Perform the following recommended maintenance procedures on a monthly basis:

Specifications

Powermatic Edge Sander Motor Nameplate
  • 1.5 HP, 1 phase, 220V Motor
  • Belt Size: 6 x 108"


                                  END OF THE PROCEDURE
Retrieved from "https://vector-space.org/wiki/index.php?title=Edge_sander_maintenance_and_specifications&oldid=1699"